Chair Mode Chair Mode

Chair Mode

Ashna Haque Ashna Haque

This article will walk you through how to use chair mode.

 

Initial Set Up

Step 1: Press chair mode button on the remote. The system will prompt you to "Calibrate the chair using the calibration card."

Step 2: Please calibrate the chair using the calibration card by standing at the side of the chair and holding the card at the chest level of the patient, above the front edge of the chair, and with the black square facing the sensor.

ONE__calibration_card_.png

Note: Please hold the calibration card by its edges ensuring your fingers do not obscure the card. 

Step 3: The system will beep when it sees the card and say “Chair calibrated." when complete.

Note: The chair must be calibrated within the 120° view of the sensor

ONE__120_degree_view.png

Subsequent Use

Step 1: Press chair mode button on the remote. 

If the patient is in the previously calibrated location, the system will automatically start monitoring.

If the patient is not detected in the previously calibrated location, the system will prompt the user to “Calibrate the chair using the calibration card.

Step 2: Please calibrate the chair using the calibration card at the chest level of the patient, towards the front edge of the chair.

Add comment

Article is closed for comments.